Ez efi--carb spacer

fridgeguy · #1 (**permalink**) 02-14-2010, 09:09 AM

I just bought the EZ EFI system and hope to have it in my hands in the next couple of weeks. I currently have a 406 full roller SBC with AFR 195 Competition Eliminators with a Holley 750HP carb on a Vic Jr intake with a Super Sucker 1 " carb spacer. My question is should I use the spacer with the EFI. That spacer was worth 10 hp and 10 lbft on the dyno (540 hp )vs no spacer . Will it, or do spacers in general have the same effect with the EZ EFI.
Thanks
Steve

TurboNova · #2 (**permalink**) 02-14-2010, 09:00 PM

Yes, a spacer will have the same effect with EFI as it does with a carb.

fridgeguy · #3 (**permalink**) 02-15-2010, 10:18 AM

Thanks, I'm looking forward to getting this system on my engine. Next question--I run a Ram Air set up where I get clod air from my rad support. Does this system have an intake air temp sensor that will allow it to compensate for changes in intake air temps?

Thanks again

Steve

SoCal · #4 (**permalink**) 02-15-2010, 10:55 AM

Yes, it does. All fuel injection systems should have one. EZ-EFI's is in the throttle body.

fridgeguy · #5 (**permalink**) 02-15-2010, 10:59 AM

Cool (no pun intended)
Thanks