I have my EZ EFI kit on my AMC 360 It has a RV style cam from Comp cams. I got it running toady and got the motor broke in and idled for 30 minutes very well it seemed havent test drove it yet but I noticed that the Fuel pressure gauge shows well above 43 is that normal or should it show the 43? Also The adaptive learning is not check marked. Where should I go from here now that it is running and am ready to get it on the road?
you have to set the pressure on the supplied regulator. best done with engine running and vac pipe removed from regulator I find. Then you set the pressure in the hand held unit to the same. ie you can set pressure lower or higher if you have reason to do so. The hand held unit must be set to the same pressure as the gauge reads.
Auto learn will not come on unless engine temp is up to a certain level (read manual) and at steady throttle.
Now running just a couple questions 
Linear Mode
